22172349 LITECOM KNX Interface S The LITECOM KNX interface links the data of a maximum of four control devices of a LITECOM installation with the KNX system. The network and the connection to the LITECOM CCD control unit are set on the user interface of the unit. The addressing data of the control device is loaded and the group addresses imported from KNX from the ETS5 configuration (ETS5 or higher) can be linked to a scene in a room or zone. This enables control via the KNX push-button and different control points. Top-hat rail PC in 1.5 module units including KNX interface and implemented software. The connection between the LITECOM installation and the KNX system is provided by the customer. Prerequisite of the function: - A browser-capable device (e.g. a computer) is available to display the web application. - Power supply 24 V DC is available (type: 22161814, not included). - LITECOM KNX interface and all LITECOM CCD control devices to be linked, as well as the KNX IP router and the displaying device (e.g. computer) are connected via an Ethernet cable and are in the same network. - Consumer name and API token of the LITECOM CCD control unit are available. - KNX-ETS5 (or higher) configuration is available. - The software version of LITECOM must be updated to version 3.0.0 or higher. - KNX operating devices were put into operation. - Exports of the required KNX group addresses are available. - KNX IP router: IP address is in the correct network and the IP address is known.